Videos

Are diamonds a machine shop's best friend? Dr. Jeffrey Badger, the host of Cutting Tool Engineering magazine's Grinding Doc Video Series, takes a close look at the question in the 41st episode of the video series.

Blue Wave Ultrasonics Sales Director Jeff Hancock demonstrates the ultrasonic cleaning process and explains the relationship between ultrasonic pressure waves and microscopic cavitation bubbles working in an aqueous solution. Blue Wave, which is located in Davenport, Iowa, provided the video as a video supplement to "Clean Sounds," a feature article published in the May 2013 issue of Cutting Tool Engineering magazine.

Dr. Jeffrey Badger, the host of Cutting Tool Engineering magazine's Grinding Doc Video Series, helps a shop that's getting cracking at the corner radius of a tungsten-carbide part in the 40th episode of the video series.

Kennametal shows a side-by-side comparison of its KM-Micro/Mini quick-change system versus a standard tool in this 2-minute demonstration, courtesy of Kennametal. While the KM-Micro/Mini tool change is complete in just half a minute, the standard tool requires 2 minutes to change, set up and gage the tool.

In this 2-minute side-by-side comparison, Kennametal shows its KM-Micro/Mini tool being changed in just half a minute versus a standard tool requiring 2 minutes to change, set up and gage.

A shop experiencing on-again, off-again waviness issues during cylindrical OD grinding operations asks Dr. Jeffrey Badger why the problem comes and goes in the 39th episode of Cutting Tool Engineering magazine's Grinding Doc Video Series. Badger, the host of video series, provides some insight.

This brief video report features a Mitsui Seiki USA Inc.'s 5-axis trunnion-style machine producing an aerospace part as well as a MAG NBV 700 5X 5-axis machine trochoidal milling a titanium blisk.

Sandvik Coromant takes a closer look at the macro trends influencing the future of the manufacturing industry in a brief video report that identifies four areas of special interest: rapid urbanization, sustainability, new advanced materials and new technologies.

In this 38th episode of Cutting Tool Engineering magazine's Grinding Doc Video Series, host Dr. Jeffrey Badger helps a shop deal with the brown, yellow and blue marks that keep appearing on an unground surface. He addresses the difference between oxidation burn, or rust, and genuine thermal damage.

Jesse Garant & Associates Metrology Center provided a brief animated view of various computed-tomography scanning analysis systems.

A shop that grinds tungsten-carbide endmills using a resin-bonded diamond wheel turned to Dr. Jeffrey Badger for the 37th episode of Cutting Tool Engineering magazine's Grinding Doc Video Series because one of the shop's wheel suppliers was talking about Q prime values.

A wheel supplier urged a shop to use a 150 mesh grit wheel to put a 0.005" radius into a part, but when the shop went from its 80 mesh grit to the smaller grit the result was horrific chatter. In fact, the shop always gets chatter from small grit wheels.