Truing Systems

Truing Parameters Calculator

The Truing Parameters Calculator is the result of a 3-year collaboration between Rush Machinery, the International Grinding Institute, and Dr. Jeffrey Badger, the ‘Grinding Doc’. Rush Machinery commissioned the project that was later presented at the 2008 CIRP General Assembly in Tokyo by Dražumerič, Badger, Klement, and Krajnik titled “Truing of Diamond Wheels–Geometry, Kinematics and Removal Mechanisms,” published in the CIRP Annals, volume 57, pages 345-348.

FC-350EX and FC-350W Wheel Truing and Dressing Machines

Rush Machinery offers the Model FC-350EX and Model FC-350W wheel truing and dressing machines, designed for truing and dressing flats, angles, and radii on diamond and CBN single wheels and multiple wheel packs.

Contact Details

CUMI America Inc.

Address

1301 Aviation Blvd

Hebron

41048

KY

United States

Map It

Phone

859-372-6606

Fax

859-372-6607

View Website

Send Email

View Buyers Guide

Defining Truing Parameters: Parts One, Two & Three

Watch Cutting Tool Engineering's special three-part video report that follows along as Rush Machinery and Jeffrey Badger, Ph.D., a.k.a. the Grinding Doc, collaborate to establish scientific truing parameters. The report encompasses episodes 83, 84 and 85 of CTE's Grinding Doc video series.

Episode 85: Defining truing parameters, part three

Thanks to a collaboration between Dr. Jeffrey Badger and Rush Machinery in Rushville, N.Y., shops now have some practical guidelines when it comes to truing parameters. Badger shares some of this new-found advice in 85th episode of Cutting Tool Engineering's Grinding Doc video series.

Episode 84: Defining truing parameters

For the 84th episode of Cutting Tool Engineering's Grinding Doc video series, Dr. Jeffrey Badger offers some preliminary results and observations from his work with Rush Machinery in Rushville, N.Y., to establish scientific truing parameters.

If you missed part one of this series, you can view the 83rd episode of the Grinding Doc video series here.

Episode 83: Defining truing parameters

For the 83rd episode of Cutting Tool Engineering's Grinding Doc video series, Dr. Jeffrey Badger visits with Rush Machinery in Rushville, N.Y., to begin a three-part series devoted to establishing scientific truing parameters. With the help of Rush Machinery President Bill Freese, Badger conducts a series of truing tests using his Grinding Doc Grindometer.

Part two of this series can be viewed here.