Toolholding & Workholding

Amacoil/Uhing has introduced the Elasto-Ring washer for use with U-Clip quick release shaft collars.

J.W. Winco Inc. offers GN 6336.13 nylon plastic star knobs with loss protection, tapped type, in inch and metric sizes.

Some workpieces, like those that are oddly shaped, large or delicate, can be a real pain in the neck. What's the best way to securely grab a hold of them?

Parting off presents challenges, but paying attention to the basics makes it a lot easier.

According to Schunk, set up changes are reduced by 90 percent with this fast, accurate quick-change, workholding and positioning system.

Kurt's HD and HDL Vises maximize workholding productivity.

Manufactured from certified 4140 heat treated steel and shipped with an MSDS to verify, Dillon Jaw Nuts and Keys reportedly provide superior wear resistance, impact resistance, higher tensile strength, and extended jaw nut life compared to jaws made from case hardened 1018 steel.

In today's environment, 5-axis has become a necessity, according to KME CNC. It helps push shops towards limitless capabilities. KME CNC's new 5-axis tombstone configuration has advanced it even further.

J.W. Winco Inc. offers GN 50.5 retaining magnet assemblies, disk-shaped, with tapped hole in metric sizes.

J.W. Winco Inc. offers GN 350.5 and GN 350.5-NI steel and stainless steel leveling sets, with spherical washer and locknut, in metric sizes.

Mencom offers its classic port adapters in a low profile black plastic shell with a M25 mounting thread.

The Look Ahead section in the May 2015 issue of Cutting Tool Engineering magazine also presents a sensory toolholder for wireless, in-process measurement of cutting forces.