Home

Turning

A just-right hard turn

04/01/2011
END USER: Axle Alliance Co. LLC, (313) 592-7438, www.daimler-trucksnorthamerica.com. CHALLENGE: Overcome workpiece variations while effectively hard turning large ring gears. SOLUTION: A workpiece measuring process for a vertical turning machine. SOLUTION PROVIDER: EMAG LLC, (248) 477-7440, www.emag.com
Read Article

Turning and hobbing combined

06/01/2012
END USER: Mercury Marine, (920) 929-5000, www.mercurymarine.com. CHALLENGE: To increase productivity when machining driveshafts and propeller shafts. SOLUTION: A lathe with a hob assembly. SOLUTION PROVIDERS: Okuma America Corp., (704) 588-7000, www.okuma.com
Read Article

Turn Right

The practice of turning threads on a lathe is well known but oftennot well-understood. Toolmakers offer their recommendations on how todo it the right way. By Bill Kennedy There are nearly as many ways to produce threads as there are types of parts that require them. Threads can be cut with a die, rolled, ground, tapped or milled, using lathes, machining centers or specialized machines.

Multitask Machines

Editor's Note: This video report is presented as a supplement to Cutting Tool Engineering's January cover story, "Down-hole, High-tech." The animation from Phillips Engineering Technologies was created to clearly illustrate the operation of a twin-ram vertical turning lathe.

Overcoming five common challenges when turning

02/01/2016
Author:
Evan Jones Thorne
While it’s nearly impossible to quantify the most common challenges or most important considerations when turning, experts agree that the five aspects of turning discussed below should be considered. It’s important to note that each factor has the potential to impact the others. So, instead of looking at each issue individually, it’s recommended machinists take a holistic best-practices approach to turning.
Read Article